
19
Figure 11. DS-8108/8116HCI-ST Rear Panel
Note: DS-8108HCI-ST provides 8 video inputs and 8 audio inputs on rear panel.
1
VIDEO IN BNC connectors for analog video input.
AUDIO IN BNC connectors for analog audio input.
2 VIDEO SPOT OUT BNC connector for monitor. Single-window view.
3
VIDEO OUT
BNC connector for video output. If VGA is connected when the device is started up,
this interface will be used as the Aux video output with live view and pop-up alarm
picture operations. If VGA is not connected, this interface will be used as the main
video output with local video display and menu operations.
AUDIO OUT BNC connector for audio output. This connector is synchronized with VIDEO OUT.
4 LINE IN BNC connector for audio input.
5 VGA
VGA output. Display local video output and menu. If VGA is connected when the
device is started up, the VIDEO OUT interface will be used as the Aux video output
with live view and pop-up alarm picture operations. If VGA is not connected, the
VIDEO OUT interface will be used as the main video output with local video display
and menu operations.
DB9 connector for connection to RS-232 devices.
7 LAN Interface Connector for LAN (Local Area Network).
Connector for USB devices.
9 eSATA Interface eSATA interface for storage and backup
10 Termination Switch
RS-485 termination switch. ON: not terminated; OFF: connect with ȍ
termination.
11
RS-485 Interface Connectors for RS-485 devices. T+, T- pin connects to PTZ.
Controller port
D+, D- pin connects to Ta, Tb pin of controller. For cascading devices, the first
DVR’s D+, D- pin should be connected with the D+, D- pin of the next DVR.
ALARM IN Connector for alarm input.
ALARM OUT Connector for alarm output.
12 GROUND Ground(needs to be connected when DVR starts up)
13 POWER 100~240VAC power supply
Comentarios a estos manuales