Syscom DS8116HCIST Manual de usuario descargar pdf (Pagina 13)

Operating Your DVR

There are numerous ways to navigate and operate your DVR. You may use the Front Panel Controls, the included IR

(Infrared) Remote, a Mouse and the Soft Keyboard.

>84-<&.?6&(/0-.&57-6:&)0-./0:8& &

Figure 5. DS-8100HCI-ST DVR Front Panel

The controls on the front panel include:

1. Power Button: Powers DVR on/off.

2. IR Receiver: Receiver for IR remote.

3. USB Ports: Universal Serial Bus (USB) ports for additional devices such as USB mouse and USB

Hard Disk Drive (HDD).

4. Status Indicators: Status indicators for different features of the DVR.

• Alarm: Alarm indicator turns red when a sensor alarm is detected.

• Ready: Ready indicator turns blue when DVR is functioning properly.

• Status: Status indicator turns blue when DVR is controlled by an IR remote. Indicator turns red when

controlled by a keyboard and purple when IR remote and keyboard is used at the same time.

• HDD: HDD indicator blinks red when data is being read from or written to HDD.

• Modem: Reserved.

• TX/RX: TX/RX indictor blinks blue when network connection is functioning properly.

• Guard: Guard indicator turns blue when the device is armed, off when the device is unarmed. The

arm/disarm state can be initiated by pressing and holding on the ESC button for more than 3 seconds

in Preview mode.

5. Alphanumeric Buttons: Alphanumeric buttons used in various menus of the DVR. Some uses include:

• Switching to the corresponding channel in Preview or PTZ Control mode.

• Inputting numbers and characters in Edit mode.

• Switching between different channels in Playback mode.

6. Control Buttons:

• ESC Button: The ESC button is used to escape to the previous menu and to arm/disarm the DVR in

Preview mode.

• REC/SHOT Button: The REC/SHOT button is used to enter the Manual Record interface. If used

when controlling a PTZ, pressing the REC/SHOT button and then a Numeric button will call a PTZ

preset.

• PLAY/AUTO Button: The PLAY/AUTO button is used to enter the Playback menu. It is also used

to turn audio on/off in the Playback menu and auto scan in the PTZ Control menu.

• ZOOM+ Button: The ZOOM+ button is used to zoom the PTZ camera in when in the PTZ Control

menu.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 120 121

Sin comentarios

Syscom DS8116HCIST Manual de usuario Pagina 13